Friday Blog Post | 4/6/18 | Week 4

Posted by Chris

For this week we accomplished making the battery holder using the 3D printer. We didn't have time to start programming the robot. We need to improve the pace we are working at and get things rolling.



Comments

Post a Comment

Popular posts from this blog

Friday Blog Post | 4/27/18 | Week 7

Image
Posted by Chris We didn't complete our goal this week of completing the figure eight. Its frustrating because the robot goes a different way each time. We finally got it to do a full figure eight but not consistently. Hopefully we can finish next week.
Read more

Friday Blog Post | 4/13/18 | Week 5

Image
Posted by Chris This week we completed our goal of programming the robot to be able to drive to Mr. Martin. Were almost done with the Solidworks assembly of our robot and we have began are almost finished with programming our robot to do the 2 laps. We were a little set back this week as the right motor was very loose so were had to take apart the right side to replace it.
Read more